(1) regular inspection triangle tension when the adjustment is still unable to meet the requirements, must replace the new triangle tape. When replacing on the same pulley belt should all be replaced at the same time, because the old and new or different, of varying lengths, the load on the uneven distribution of V-belts, causing vibration V-belt, transmission is not smooth, reducing the V-belt drive work effectiveness.
(2) the use of, V-belt operating temperature should not exceed 60 ℃, do not casually coated with grease. Such as the discovery of the surface of the V-belt light, indicating that the V-belt has been slipping, first remove the surface of the belt dirt, and then coated with the right amount of belt wax. Clean the V-belt with warm water, do not use cold water and hot water.
(3) V-belts for various types, should not be coated with rosin or sticky substance, but also to prevent the contamination of the oil, butter, diesel and gasoline, otherwise it will corrode the V-belt and shorten life. V-belt can not be stained with oil, otherwise it will slip.
(4) V-belt when not in use to keep good, should be kept in the temperature is relatively low, no direct sunlight and no oil and corrosive smoke to prevent its deterioration.